Metrologic Hand-Held Scanner Guía de usuario descargar pdf (Pagina 15)

Figure 9.

CANNER

NSTALLATION

USB (-38 and -106)



1. Turn off the host system.

2. Plug the 10-pin RJ45 end of the

USB cable into the 10-pin socket

on the MS9590. There will be an

audible click when the connector

lock engages.

3. Plug the USB Type A end of the

cable into the host's USB port.

4. Turn on the host device.

USB is the default communication protocol for the MS9590-106.

Both the MS9590-38 and the MS9590-106 have USB Keyboard

Emulation Mode enabled by default when shipped from the factory.

Both the MS9590-38 and the MS9590-106 are configurable for

Bi-Directional Serial Emulation mode. IBM OEM support is only

available with the MS9590-106.

Refer to the USB section in the MetroSelect Single-Line Configuration

Guide (

MLPN

00-02544) for USB configuration bar codes.

The scanner is shipped from the factory configured to set of default

conditions. Plugging the scanner into a port on the host system does

not guarantee that the scanned information will be communicated

properly to the host device. The scanner and host device must use the

same communication protocol. Please refer to the MetroSelect Single-

Line Configuration Guide or the help files provided with MetroSet2 for

instructions on changing the scanner’s factory default configuration.

See caution on page 6.



The MS9590-38 and the MS9590-106 meet the requirements for Full Speed USB

hardware. These interfaces also support all emulation types previously supported by

Metrologic in Low Speed USB scanners.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Sin comentarios

Metrologic Hand-Held Scanner Guía de usuario Pagina 15