Metrologic IS4320-41 ScanKey Guía de usuario descargar pdf (Pagina 10)

Audible Indicators

The scanner provides sounds to signal certain conditions. To change the

volume (three settings are available) or turn the beeper off, refer to the

Programming Guide section: Beeper Tones.

One Beep When the scanner first receives power, diagnostic prompts

are displayed and then the scanner "beeps." After that, each

time the scanner successfully reads a bar code, it "beeps."

Razzberry If, upon power up, the scanner emits a razzberry tone, then

Tone the scanner has failed diagnostics.

Note: The scanner can be programmed to emit a razzberry

tone when the timeout occurs during communica-

tion between the host and scanner. Refer to the

Programming Guide section: Audible Indicators for

Communication Timeouts.

Three Beeps When the scanner enters the program mode, it beeps three

times then the message "PROGRAM MODE ENABLED"

appears. When the scanner exits the program mode, it beeps

three times and the message "READY TO SCAN"

reappears.

Note: The scanner can be programmed to emit three beeps

when the timeout occurs during communication be-

tween the host and scanner. Refer to the Programm-

ing Guide section: Audible Indicators for Commun-

ication Timeouts.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Sin comentarios

Metrologic IS4320-41 ScanKey Guía de usuario Pagina 10